Everything below concerns trans-3-hexenoyl. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-08-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
特沙莫瑞林的检测通常依赖反相高效液相色谱和质谱联用。反相色谱可分离肽主峰与缺失序列、氧化产物等杂质，质谱则提供精确质量以确认身份。对于复杂基质中的定量，常采用液相色谱-串联质谱，并配合固相萃取或蛋白沉淀。生物样品中的肽易降解，因此采集和处理条件会影响结果。
稳定性研究通常考察温度、光照、湿度和 pH 对肽链的影响。冻干粉在低温避光条件下较为稳定，复溶后则需控制保存时间并避免反复冻融。肽类可能发生氧化、脱酰胺、水解和聚集，这些变化会改变色谱纯度。强制降解实验用于识别主要降解途径并验证分析方法的专属性。
Tesamorelin is a synthetic peptide built from 44 amino acids and classified with the growth hormone–releasing hormone family. Its sequence corresponds to the human GHRH(1-44) backbone, carrying one structural change at the amino terminus. That change is a trans-3-hexenoyl group placed where the natural peptide would have an unmodified end. The modification is the feature that separates the compound from the endogenous hormone in name, in stability, and in how it is handled in the laboratory.
The hexenoyl cap slows the enzyme step that trims the amino terminus of native GHRH, the same step that shortens its active lifetime in circulation. As a result, the modified peptide persists longer in plasma than the unmodified hormone in side-by-side comparison. Receptor activity stays broadly comparable, because the added group sits away from the residues that contact the binding site. This combination, preserved receptor activity with reduced degradation, explains why the analog was developed instead of the native sequence.
| Property | Value | Notes |
|---|---|---|
| 外观 | 白色至类白色冻干粉 | 可能具吸湿性 |
| 溶解性 | 溶于水和水性缓冲液 | 典型肽类行为 |
| 冻干粉储存 | -20°C 或 2-8°C，避光 | 长期稳定性较好 |
| 复溶后储存 | 2-8°C，短期 | 避免反复冻融 |
| 常用分析 | RP-HPLC 与 LC-MS | 纯度与身份确认 |
Identity and purity are assessed with reversed-phase high-performance liquid chromatography, which separates the peptide from truncated or oxidized forms. Mass spectrometry confirms the expected molecular weight, and peptide mapping after enzymatic digestion verifies the amino acid sequence. Water content is measured because residual moisture affects stability, and tests for aggregates or particulates are standard for injectable peptides. Circular dichroism can indicate whether the molecule has adopted an unexpected secondary structure in solution.
Research supply is often accompanied by a certificate of analysis listing chromatographic purity, mass confirmation, and storage conditions. Laboratories compare that document with an independent test when material is intended for bench work, since certificates describe a batch rather than an individual vial. Published studies usually state the source and purity of the peptide because small differences in purity can shift measured activity. Full analytical validation is rarely reported, which leaves batch-to-batch comparability an open question.
A Phase 3 program led to regulatory approval in the United States in 2010 for reduction of excess visceral abdominal fat in adults with HIV and lipodystrophy. Subsequent studies examined effects on liver fat, muscle area, and metabolic markers, with mixed findings for some endpoints. Long-term cardiovascular outcomes and effects on mortality remain uncertain because most trials were relatively short and focused on imaging-based fat measurements. Use in populations without HIV has been studied experimentally but is not part of the approved indication.
Tesamorelin is a synthetic analog of growth hormone-releasing hormone, a peptide hormone produced by the hypothalamus. The molecule retains the 44-amino-acid sequence of human GHRH and carries a trans-3-hexenoyl modification at its N-terminus. This modification increases resistance to enzymatic degradation and extends the peptide's functional stability relative to native GHRH. The compound is supplied as a lyophilized powder for reconstitution and subcutaneous administration in clinical settings. Its development code was TH9507, and it belongs to the GHRH analog class. It is not a growth hormone product; instead, it acts upstream to stimulate endogenous growth hormone release.
Clinical interest in tesamorelin arose from the need to address visceral adiposity in people living with HIV. Antiretroviral therapy improved survival but was associated in some patients with central fat accumulation, altered lipid profiles, and metabolic complications. This condition, often called HIV-associated lipodystrophy, involves excess visceral adipose tissue that is difficult to manage through diet and exercise alone. Investigators evaluated tesamorelin because GHRH analogs can stimulate growth hormone secretion and influence fat distribution without direct liposuction or invasive procedures.
Baechu-kimchi (배추김치) spicy napa cabbage kimchi, made from whole cabbage leaves Baechu-geotjeori (배추겉절이) unfermented napa cabbage kimchi Bossam-kimchi (보쌈김치) wrapped kimchi Baek-kimchi (백김치) white kimchi, made without chili pepper Dongchimi (동치미) a non-spicy watery kimchi Nabak-kimchi (나박김치) a mildly spicy watery kimchi Chonggak-kimchi (총각김치) cubed chonggak "ponytail" radish, a popular spicy kimchi Kkakdugi (깍두기) spicy cubed Korean radish strongly-scented kimchi containing fermented shrimp Oi-sobagi (오이소박이) cucumber kimchi that can be stuffed with seafood and chili paste, and is a popular choice during the spring and summer seasons Pa-kimchi (파김치) spicy green onion kimchi Yeolmu-kimchi (열무김치) is also a popular choice during the spring and summer, and is made with yeolmu radishes, and does not necessarily have to be fermented. Gat-kimchi (갓김치), made with Indian mustard Yangbaechu-kimchi (양배추 김치) spicy cabbage kimchi, made from "headed" cabbage leaves (as opposed to napa cabbage) Kimchi from the northern parts of Korea tend to have less salt and red chili and usually do not include brined seafood for seasoning. Northern kimchi often has a watery consistency. Kimchi made in the southern parts of Korea, such as Jeolla Province and Gyeongsang Province, uses salt, chili peppers and myeolchijeot (멸치젓, brined anchovy allowed to ferment) or saeujeot (새우젓, brined shrimp allowed to ferment), myeolchiaekjeot (멸치액젓), anchovy fish sauce, kkanariaekjeot (까나리액젓), liquid anchovy jeot, similar to fish sauce used in Southeast Asia, but thicker.
After the polymerisation of the separating gel, the alcohol is discarded and the residual alcohol is removed with filter paper. After addition of APS and TEMED to the stacking gel solution, it is poured on top of the solid separation gel. Afterwards, a suitable sample comb is inserted between the glass plates without creating bubbles. The sample comb is carefully pulled out after polymerisation, leaving pockets for the sample application. For later use of proteins for protein sequencing, the gels are often prepared the day before electrophoresis to reduce reactions of unpolymerised acrylamide with cysteines in proteins. By using a gradient mixer, gradient gels with a gradient of acrylamide (usually from 4 to 12%) can be cast, which have a larger separation range of the molecular masses. Commercial gel systems (so-called pre-cast gels) usually use the buffer substance Bis-tris methane with a pH value between 6.4 and 7.2 both in the stacking gel and in the separating gel. These gels are delivered cast and ready-to-use. Since they use only one buffer (continuous gel electrophoresis) and have a nearly neutral pH, they can be stored for several weeks. The more neutral pH slows the hydrolysis and thus the decomposition of the polyacrylamide. Furthermore, there are fewer acrylamide-modified cysteines in the proteins. Due to the constant pH in collecting and separating gel there is no stacking effect. Proteins in BisTris gels can not be stained with ruthenium complexes.
or more) with no big change in temperature. When there are only 500 atoms, however, the substrate is almost immediately vaporized by the deposition. Something similar happens in biophysical simulations. The temperature of the system in NVE is naturally raised when macromolecules such as proteins undergo exothermic conformational changes and binding.
Sources: en.wikipedia.org
They were characterized by producing flowers in spring on the previous year's wood, and often again in summer or early autumn on the current year's growth. The former Fortunei Group (also known as Florida Group, although it had nothing to do with C. florida) comprised cultivars with double or semi-double flowers that were produced on the previous year's growth in spring. Hybridization has made it impossible to keep the original Groups separate: there are a number of cultivars that produce both single and double flowers, or that only produce semi-double or double flowers under certain conditions. Late Large-flowered Group: Comprises the former Lanuginosa Group and Jackmanii Group. Cultivars of the Lanuginosa Group were derived mainly from C. lanuginosa, either directly or indirectly. The Jackmanii Group covered cultivars produced from a cross between C. viticella (or a derivative therefrom) and a member of the Patens Group. Both Groups produce their flowers on the current year's growth in summer and autumn. It is often impossible to say whether a cultivar belongs to the Lanuginosa Group or to the Jackmanii Group, due to hybridization and/or lack of information on the parentage, so it is not possible to maintain these Groups.
=== Counterfeit impact factors === Fake impact factors or bogus impact factors are produced by certain companies or individuals. According to an article published in the Electronic Physician, these include Global Impact Factor, Citefactor, and Universal Impact Factor. Jeffrey Beall maintained a list of such misleading metrics. Another deceitful practice is reporting "alternative impact factors", calculated as the average number of citations per article using citation indices other than JCR such as Google Scholar (e.g., "Google-based Journal Impact Factor") or Microsoft Academic. False impact factors are often used by predatory publishers. Consulting Journal Citation Reports' master journal list can confirm if a publication is indexed by the Journal Citation Reports. The use of fake impact metrics is considered a red flag.
Estradiol has been assessed for use by rectal administration in a number of studies. Uses of estradiol by this route have included treatment of menopausal symptoms in postmenopausal women. Rectal administration of estradiol is described as qualitatively and quantitatively similar to vaginal administration of estradiol. The use of estradiol by the rectal route considerably bypasses the liver and hence the first-pass metabolism that occurs with oral estradiol, similarly to other parenteral routes of estradiol such as vaginal and transdermal administration. Irritation of the intestines does not usually occur with rectal estradiol. The use of estradiol by the rectal route is not well-accepted by all individuals, and due to its inconvenience, it has been said that rectal administration of estradiol has gained no practical clinical importance. Lauritzen (1986) reported that 3 hours after a single rectal dose of 1 mg micronized estradiol, estradiol levels increased by 620 pg/mL and estrone levels increased by 120 pg/mL. Subsequently, Lauritzen (1987, 1990) reported that 0.5 mg/day and 1 mg/day rectal estradiol resulted in respective estradiol levels of 363 pg/mL and 515 pg/mL 6 hours following the last dose. These estradiol levels are fairly similar to those achieved by vaginal estradiol. The estradiol-to-estrone ratio of rectal estradiol is about 5:1, which likewise is the same as that of vaginal estradiol.
=== Prostate cancer === The backdoor pathway to DHT plays a role in the development of androgen-sensitive cancers, such as prostate cancer. In some cases, tumor cells have been found to possess higher levels of enzymes involved in this pathway, resulting in increased production of DHT. Androgen deprivation therapy (ADT) is a common treatment for prostate cancer, which involves reducing the levels of androgens, specifically T and DHT, in the body. This treatment is done through the use of medications that aim to block the production or action of these hormones. While ADT can be effective in slowing the growth of prostate cancer, it also has several drawbacks, one of which is the potential for increased production of P4 and activation of the backdoor pathway of DHT biosynthesis where P4 is a substrate. Normally, this pathway is not very active in healthy adult males, as the majority of DHT is produced through the classical pathway, which involves the direct conversion of T into DHT by one of the SRD5A isozymes. However, when T levels are reduced through ADT, the body may compensate by increasing the production of P4, which the backdoor pathway can then use as a substrate. One of the main drawbacks of this increased production of P4 leads to an increase in DHT levels, which fuel the growth of prostate cancer cells. This increased production of P4 and DHT can result in the cancer becoming resistant to ADT and continuing to grow and spread.
Sources: en.wikipedia.org
反相高效液相色谱用于分离和纯度评估，质谱用于分子量确认。肽图谱或串联质谱可进一步验证序列。具体方法需根据样品基质和监管要求选择。
高温、强光、潮湿和反复冻融都会加速肽降解。冻干粉通常建议低温避光保存。复溶后的溶液稳定性较短，应依据验证数据确定保存条件。
氧化、脱酰胺和截短肽可能影响色谱纯度和生物活性读数。不同批次之间这些杂质的相对比例可能不同。是否具有临床意义取决于杂质水平、给药途径和暴露量，尚无统一阈值。
No. It is a peptide that acts upstream of growth hormone release, while growth hormone is the hormone itself. The two differ in size, in receptor, and in how the body clears them.